To support a SanDisk EXTREME PRO M.2 NVMe 3D SSD, the system must have an M.2 connector with only an M key. The table and figure below shows mechanical compatibility between the SSD connector types and SSD devices. However, the specification allows the SSD connector to be implemented to support the following:Īn M.2 SSD connector can have B+M key, or an M key only. To help plug in the correct peripheral type into the target M.2 connector, the standard defines keys A through M on the connector and corresponding notches A through M on the device.Īn SSD M.2 connector for SSD uses keys in position B and M to prevent a non-SSD device from being plugged into it. However, in both cases, it must be securely screwed down with an appropriate retaining screw. Thus, the SanDisk EXTREME PRO M.2 NVMe 3D SSD can fit into a M.2 2280 or larger slot. It is a standard 22mm wide x 80 mm long, and up to 2.4mm tall.All M.2 NVMe SSDs are a standard 22mm, however, other products may vary in length as 30, 42, 60, 80 or 110 mm.Ī longer slot space can generally accommodate a shorter device. The SanDisk EXTREME PRO M.2 NVMe 3D SSD is an M.2 2280 form factor. These requirements are further explained in the sections below. It is best to contact the motherboard or PC manufacturer for possible updates to the BIOS and Chip set and ensure the operating system is current with the latest patches and updates prior to installation of new hardware. On software side, it is important to know, the drivers are a function of the host BIOS and Chip set on the motherboard and Operating System (OS) installed must support PCIe NVMe SSDs. On hardware side, the motherboard must include an M.2 connector that supports PCIe and NVMe SSDs. There are both hardware and software requirements for SanDisk EXTREME PRO M.2 NVMe 3D SSD.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |